Fuchs915
New Member
- Messages
- 20
- Location
- From Kent, living in Essex
Hi all,
I have had a play with my secondhand Cebora 130 Pocket welder today. First time I have used it (only had a few attempts on a MIG before) and thought i would get your thoughts. The shot along the weld shows the top and the other one is the shot from below. I joined 2 pieces of 1.2mm mild steel (seems to have a coating - zinc?). The gas was very low, so not sure I was getting lot of shielding. Set to minimum (30 amps I think) and wire speed about half way round the dial.
Any feedback welcomed.
Thanks
Kevin
I have had a play with my secondhand Cebora 130 Pocket welder today. First time I have used it (only had a few attempts on a MIG before) and thought i would get your thoughts. The shot along the weld shows the top and the other one is the shot from below. I joined 2 pieces of 1.2mm mild steel (seems to have a coating - zinc?). The gas was very low, so not sure I was getting lot of shielding. Set to minimum (30 amps I think) and wire speed about half way round the dial.
Any feedback welcomed.
Thanks
Kevin