Morning All,
I am after some recommendations for removal of the locking wheel nut shown below. I do not have a welder only a 70's Wolf drill. The bit shown has disintegrated, presumably due to too much speed.
Could somebody please advise?
Many thanks in advance.
P.s., I have tried the Irwin/Snap on spiral fluted extractors but there is too little meat to grab on to.
I am after some recommendations for removal of the locking wheel nut shown below. I do not have a welder only a 70's Wolf drill. The bit shown has disintegrated, presumably due to too much speed.
Could somebody please advise?
Many thanks in advance.
P.s., I have tried the Irwin/Snap on spiral fluted extractors but there is too little meat to grab on to.