steve202
ǝlʇıʇ ɹǝsn ɯoʇsnɔ
- Messages
- 422
What am i doing to cause this? Instead of continuous runs, i often like (on thin stuff) to clunk away and do spots to stop it blowing through and get the penetration i want. Anyway, i hope you can see from the crap pic that in every weld there is a little hole. I dont usually get it when doing this but has happened a few times. Its a sill patch repair.
I would like to take a guess at it being me pulling the torch away too fast before releasing the trigger, or the wire speed too slow for the power setting?
Somebody put me out of my misery please
Its a 190 welder. 3 phase.
I would like to take a guess at it being me pulling the torch away too fast before releasing the trigger, or the wire speed too slow for the power setting?
Somebody put me out of my misery please
Its a 190 welder. 3 phase.