Hopefully there is someone out there who can help with two problems. Firstly I am importing Plasma Cutters (you may have seen some of the write ups about the product) and have been asked several times about Plasma Cutter Cutting Guides. These have been described to me and I have spent many months searching. Finally, I found the tools in a very obtuse place on the Earth.
As I do not profess to be an expert, I am looking for someone who does a lot of Plasma Cutting who has the need to cut accurate straight lines or curves, who can test this for me before I rush in, buy loads and get into loads of trouble (again) with the financial controller (sometimes known as the wife), or Toy Police as they are sometimes known.
I have also got a couple of sample TIG Welders and again am looking for someone to test them for me before allowing them to go for sale.
Pictures below are of the Cutting Guides using suction and magnetic clamps to fix the guides position.
As I do not profess to be an expert, I am looking for someone who does a lot of Plasma Cutting who has the need to cut accurate straight lines or curves, who can test this for me before I rush in, buy loads and get into loads of trouble (again) with the financial controller (sometimes known as the wife), or Toy Police as they are sometimes known.
I have also got a couple of sample TIG Welders and again am looking for someone to test them for me before allowing them to go for sale.
Pictures below are of the Cutting Guides using suction and magnetic clamps to fix the guides position.