Long story short:
Colleague: "Want a welder? - something wrong with the feed. Cluttering up the shed. I'll never use it. Otherwise its going to the tip."
Me: "OK" - nothing ventured, etc.
Result - Get it home, 2 minutes with a screwdriver to discover that one of the gears in the wire feed has lost all its teeth.
I've seen all the negative comments on here about Wolf, no spares backup, etc - so I guess the only hope is if anyone has a similar scrapper due to a blown circuit board, or other fault.
Otherwise, are there any bits that anyone else could use before I take it to the tip?
Looking at the nozzle, I reckon its never seen more than 20 minutes use!
It cost me nothing, so I haven't lost anything.
Great forum by the way - glad I found it.
Andy
Colleague: "Want a welder? - something wrong with the feed. Cluttering up the shed. I'll never use it. Otherwise its going to the tip."
Me: "OK" - nothing ventured, etc.
Result - Get it home, 2 minutes with a screwdriver to discover that one of the gears in the wire feed has lost all its teeth.
I've seen all the negative comments on here about Wolf, no spares backup, etc - so I guess the only hope is if anyone has a similar scrapper due to a blown circuit board, or other fault.
Otherwise, are there any bits that anyone else could use before I take it to the tip?
Looking at the nozzle, I reckon its never seen more than 20 minutes use!
It cost me nothing, so I haven't lost anything.
Great forum by the way - glad I found it.
Andy