Gareth J
Member
- Messages
- 3,333
- Location
- North Cornwall
Turns out it will fit in the lathe (just - with 2" of the tailstock overhanging) and there is a centre each end, one was full of gunk. But I've put the front in the 4jaw rather than on a centre - it was a bit out - plus, I'd have had to make a drive dog to fit.
Makes space a bit tighter but still ok to turn down the worn bit - down from 40mm to 39.35 diameter before it was cutting cleanly. Hopefully that's within the scope of one of those crush rings.
Makes space a bit tighter but still ok to turn down the worn bit - down from 40mm to 39.35 diameter before it was cutting cleanly. Hopefully that's within the scope of one of those crush rings.