Shox Dr
Chief Engineer to Carlos Fandango
- Messages
- 17,983
- Location
- East Yorkshire
Looking to replace a 0-5mm chuck with ER8 collets. Main use will be holding drills.
Only look to be available in 1mm increments. 1-2 2-3 ... and non below 1mm
Has any one used this setup? What are they like at holding drills at the extreme of the collet size
ie 2.1 in a 2-3mm collet Etc.
Only look to be available in 1mm increments. 1-2 2-3 ... and non below 1mm
Has any one used this setup? What are they like at holding drills at the extreme of the collet size
ie 2.1 in a 2-3mm collet Etc.