ron bridges
New Member
- Messages
- 26
- Location
- Arkadelphia, Arkansas USA
hello all, mods move as needed. i've got a project going on and today ran into a wall. i use a titanium 125 flux welder. i was changing wire spools on it and the wire had a kink in it i knew i should have cut it off but went ahead. after it got about 8=10 inches in it jammed up so i started to get it straightened out and as i pulled the wire back it snapped off inside the lead maybe 6-7 inches in. that means i have to replace the tube inside the lead at about $25 or buy a new lead at??? i know nothing about these guns or how to do this any ideas thanks!