1/2" table top and 60 x 60 x 4 mm box.
The top is roughly 6 x 3ft.
Where it was cut at the ends its bent down the whole way across about a foot from the end.
When I clamp it to my box it seems to straighten out and not bend the box. Should I weld it to it or would that warp it more or should I bolt it to it.
I wanted to leave a gap around the edge to clamp too but that won't be possible now as I need to go out to the edges to try to straighten it.
All our welding was done on the ground but I'm getting past that stage now and I hoped a good flat table at waist height would make things easier, I'm very disappointed its not straight and will be gutted if I've spent all this money and end up with a crooked table.
The top is roughly 6 x 3ft.
Where it was cut at the ends its bent down the whole way across about a foot from the end.
When I clamp it to my box it seems to straighten out and not bend the box. Should I weld it to it or would that warp it more or should I bolt it to it.
I wanted to leave a gap around the edge to clamp too but that won't be possible now as I need to go out to the edges to try to straighten it.
All our welding was done on the ground but I'm getting past that stage now and I hoped a good flat table at waist height would make things easier, I'm very disappointed its not straight and will be gutted if I've spent all this money and end up with a crooked table.