Jay1st
AdeptusMechanicus wanna be.
- Messages
- 298
- Location
- South West FRANCE
Ok, no idea where to post this so i put here.....
I live in an old house with 3 phase 380V, very good for some stuff like the car lift or the drill press, but very ****ty for other stuff !!!
The problem is my CNC plama cutter, the plasma generator is a single phase unit on 220v, and when used @ full power after 2mn the house's general cricuit protection ( provided by the energy company) will trip as it's fully loading a SINLGE phase out of the 3.
Is there any gimmick to make it less succeptible to unbalancing ? or rather is there a way to balance the lines according the the power needed by the plasma ?
I live in an old house with 3 phase 380V, very good for some stuff like the car lift or the drill press, but very ****ty for other stuff !!!
The problem is my CNC plama cutter, the plasma generator is a single phase unit on 220v, and when used @ full power after 2mn the house's general cricuit protection ( provided by the energy company) will trip as it's fully loading a SINLGE phase out of the 3.
Is there any gimmick to make it less succeptible to unbalancing ? or rather is there a way to balance the lines according the the power needed by the plasma ?