Kram
Member
- Messages
- 6,227
- Location
- Sussex
There is a line of bricks cemented in going all the way to house, with solid deep concrete right where the posts should be. I had a breif go with the sds drill and chisel.
As its a slope, we need to recess the concrete gravel board down 200mm by the post, or chop a lot off it. The bricks and concrete seem too massive to pull out as a lump.
We could get an 8" diamond core drill but they are not cheap. The engine auger should have plenty of power to drive it and Id need to make up a forced coolant spindle adaptor.
Could drill lots of 20mm holes to break it up.
Could smash the bottom half of a post to reveal the 4x 6mm rebars and cement those in, or bolt them down.
Any better ideas?
Thanks
Mark