Trying to work on the 6x6, on going project several years, fitted is now a Rover V8 3.5 EFI, the car started life as a carbs V8, then converted to diesel, so I am I the process of converting to petrol, and trying to fit the high pressure fuel lines and pump.
I am using an external HP pump, and copper pipe, but my problem, is the connection to the engine.
This was made in hard plastic which each end had compression fittings, I have managed to get the pipe but is minus the pipe fitting at the bottom where it will go back to the tank, any ideas o managing to fit a fitting back to the hard plastic?
I am using an external HP pump, and copper pipe, but my problem, is the connection to the engine.
This was made in hard plastic which each end had compression fittings, I have managed to get the pipe but is minus the pipe fitting at the bottom where it will go back to the tank, any ideas o managing to fit a fitting back to the hard plastic?