Fazerruss
Member
- Messages
- 3,033
Evening all, today's little job was to make a pair of erm.....
It think it is part of the chassis from ww2 jeep.
So off we go....
First I cut some sheet and did a test bend to check dimensions.
All was good so I bend the pieces full length.
They then needed a bend at each end. One is 18 degrees and other 15.7
It think it is part of the chassis from ww2 jeep.
So off we go....
First I cut some sheet and did a test bend to check dimensions.
All was good so I bend the pieces full length.
They then needed a bend at each end. One is 18 degrees and other 15.7