pawsnizzy
Forum Supporter
- Messages
- 790
- Location
- Derbyshire, UK
Hi all,
Appologies if I've put this in the wrong place I'm knocking up a reservoir for a TIG cooler out of 3mm alum and I have procured alum bosses to weld on for inlet/filler etc. Is the idea of these to sit the smaller diameter lip in the hole and weld them in from the rear. just fillet around them or both - or none of these?
Don't want to balls it up obviously
Thanks
Dave
Appologies if I've put this in the wrong place I'm knocking up a reservoir for a TIG cooler out of 3mm alum and I have procured alum bosses to weld on for inlet/filler etc. Is the idea of these to sit the smaller diameter lip in the hole and weld them in from the rear. just fillet around them or both - or none of these?
Don't want to balls it up obviously
Thanks
Dave