dobbslc
Member
- Messages
- 10,931
- Location
- Hertfordshire UK
I was doing a long awaited service on the Yamaha TRX yesterday and when refitting the oil filter housing I stripped two 6mm bolts!
Here's a photo.
The setting was only 10nm so very light! It did feel like I was over doing it but trusted the torque wrench, it's a 1/4" Teng one with very little use.
Do these things go wrong?
Luckily the aluminium case seems ok with only a couple of small bits of thread coming out and some new bolts nipped up ok.
Here's a photo.
The setting was only 10nm so very light! It did feel like I was over doing it but trusted the torque wrench, it's a 1/4" Teng one with very little use.
Do these things go wrong?
Luckily the aluminium case seems ok with only a couple of small bits of thread coming out and some new bolts nipped up ok.