RaceDiagnostics
Forum Supporter
- Messages
- 2,891
I've been looking for a suitable high temp loctite for a loose valve guide I found when changing the valve stem seals last winter. It was on cylinder one intake valve.
Since putting the car back on the road I have covered about 800 miles and decided to pull all the spark plugs to have a look at their condition.
Cylinder 1 was a shock.
2
3
4
5
6
7
8
So my plan is to buy a new guide and an oversize guide and see which fits best then do a light knurl and glue it in.
Looking at loctite 620 a high temp pin/bearing adhesive and 2620 a higher temp thread lock, any thoughts on which would be the best?
Since putting the car back on the road I have covered about 800 miles and decided to pull all the spark plugs to have a look at their condition.
Cylinder 1 was a shock.
2
3
4
5
6
7
8
So my plan is to buy a new guide and an oversize guide and see which fits best then do a light knurl and glue it in.
Looking at loctite 620 a high temp pin/bearing adhesive and 2620 a higher temp thread lock, any thoughts on which would be the best?