Evening all,
I'm currently learning fusion 360 again and I am having a issue trying to figure out how to put a add on onto a taper. I have a design I want to 3d print.
Here is a rough drawing if someone could help would be appreachitated.
Needs no infill and must be able to be wrapped around a shaft,
35mm shaft.
75mm ish top
50mm ish bottom.
Split so can wrap around.
Hinged or able to be clicked closed. (Pin/fastened)
Many thanks in advance.
I'm currently learning fusion 360 again and I am having a issue trying to figure out how to put a add on onto a taper. I have a design I want to 3d print.
Here is a rough drawing if someone could help would be appreachitated.
Needs no infill and must be able to be wrapped around a shaft,
35mm shaft.
75mm ish top
50mm ish bottom.
Split so can wrap around.
Hinged or able to be clicked closed. (Pin/fastened)
Many thanks in advance.