I need to remove a notoriously tight nut on my Harley- final drive pulley. One owner needed his full 18 stone and a six foot scaffold pole!
I'm old and decrepit and 10 stone soaking wet, so as a precaution I'm thinking of getting hold of an air impact wrench for the job. I also live in the middle of nowhere so once I embark on this I have to finish it.
My question is whether my old and equally decrepit 50l compressor will handle the impact wrench? I don't know its cfm, but it's atypical cheap diy number. I'm well tooled up for most things but not this.
Any thoughts very welcome.
I'm old and decrepit and 10 stone soaking wet, so as a precaution I'm thinking of getting hold of an air impact wrench for the job. I also live in the middle of nowhere so once I embark on this I have to finish it.
My question is whether my old and equally decrepit 50l compressor will handle the impact wrench? I don't know its cfm, but it's atypical cheap diy number. I'm well tooled up for most things but not this.
Any thoughts very welcome.