Hood
I am obsessed.
- Messages
- 16,936
- Location
- Carnoustie, Scotland
Has anyone used a single phase output VFD?
The reason I am looking for one is a bandsaw (not mine) is too fast for stainless in my opinion, it is 80m/min and I reckon 40 is more the speed.
The motor is a weirdo, 2800rpm with a 90S frame size but tiny flange and output shaft only 14mm so trying to get a 1400rpm motor is proving difficult.
I found info online today, in my searches about single phase input/output VFDs and they seemed like the ideal solution as it would allow slower rpm for stainless and higher for Alu.
The reason I am looking for one is a bandsaw (not mine) is too fast for stainless in my opinion, it is 80m/min and I reckon 40 is more the speed.
The motor is a weirdo, 2800rpm with a 90S frame size but tiny flange and output shaft only 14mm so trying to get a 1400rpm motor is proving difficult.
I found info online today, in my searches about single phase input/output VFDs and they seemed like the ideal solution as it would allow slower rpm for stainless and higher for Alu.