Hood
I am obsessed.
- Messages
- 16,869
- Location
- Carnoustie, Scotland
LED board Mk2.
I made it 2 part due to lack of room at the LEDs, so now have a connection board with the resistors that I will fix into the bottom of the cabinet. I increased the resistance and although it is still bright it is not bad at all. That allowed me to use smaller wattage resistors which is a bonus. The pic makes it look extremely bright but it is not.
Label machine is at the workshop so I will have to wait until tomorrow before I can label the terminals. Then all I need to do is run a new wire then connect to the servo drives breakout boards and configure the I/O in the servo drives software. Not sure if I have any spare outputs on the VFD, if not I may be able to route the current signals via the PLC and make it work that way.
I made it 2 part due to lack of room at the LEDs, so now have a connection board with the resistors that I will fix into the bottom of the cabinet. I increased the resistance and although it is still bright it is not bad at all. That allowed me to use smaller wattage resistors which is a bonus. The pic makes it look extremely bright but it is not.
Label machine is at the workshop so I will have to wait until tomorrow before I can label the terminals. Then all I need to do is run a new wire then connect to the servo drives breakout boards and configure the I/O in the servo drives software. Not sure if I have any spare outputs on the VFD, if not I may be able to route the current signals via the PLC and make it work that way.