hotponyshoes
Member
- Messages
- 6,415
- Location
- Somerset. Uk
Anybody seen a tube notcher that does not only take the standard toothed holesaws?
They seem to be the weak link in my notcher, especially if trying just to take a partial cut plus the finish is not quite as clean as I would like.
I know I can get something for a few £k that takes a milling cutter but I was wondering if there was a 'midrange' that I could fit the Armeg Carbide Tipped hole cutter or something like that into?
They seem to be the weak link in my notcher, especially if trying just to take a partial cut plus the finish is not quite as clean as I would like.
I know I can get something for a few £k that takes a milling cutter but I was wondering if there was a 'midrange' that I could fit the Armeg Carbide Tipped hole cutter or something like that into?