Cret
Member
- Messages
- 150
Ok, so my bandsaw works a treat now but next up is my drill press.
I thought recently where it had play that it was the bearing just above the chuck, but on closer inspection it's not from that.
The issue is down to wobble in the pillar section that comes out/down with the chuck. It has some side to side movement which means no guarantee of a straight cut sadly.
This is s B&Q Macallister machine I've had for years but I can't find an exploded diagram or manual online, so I'm not sure whether there's anything much I can do about it?
Any ideas? Thanks
I thought recently where it had play that it was the bearing just above the chuck, but on closer inspection it's not from that.
The issue is down to wobble in the pillar section that comes out/down with the chuck. It has some side to side movement which means no guarantee of a straight cut sadly.
This is s B&Q Macallister machine I've had for years but I can't find an exploded diagram or manual online, so I'm not sure whether there's anything much I can do about it?
Any ideas? Thanks