Gerard Fazzini
Member
- Messages
- 32
- Location
- Edinburgh, Scotland
Is there a way in which to control the length of wire that protrudes from the torch nozzle?
When I start putting down a bead, the wire tip length seems to reduce to the point where it's very close to the nozzle and I can't really see where it enters the pool. If I try to pull the nozzle away, I lose the arc.
Is it possible to maintain the wire at a slightly longer length without losing the arc and weld quality?
When I start putting down a bead, the wire tip length seems to reduce to the point where it's very close to the nozzle and I can't really see where it enters the pool. If I try to pull the nozzle away, I lose the arc.
Is it possible to maintain the wire at a slightly longer length without losing the arc and weld quality?