Bigjohnny5
New Member
- Messages
- 12
- Location
- Kent
hi
I need to get myself a welder for a steel boat project I'm working on
Firstly I will need to weld some 16mm round steel bar onto the edges of some 2mm steel sheet
What would be the best way to weld this ? Arc or mig ?
I was looking for something not to expensive and as I will be working in the open I was thinking either a small gasless mig or a stick welder
I have been looking at...
http://www.screwfix.com/p/p/17497?u...Impax IM-ARC140/10/115 140amp Arc Welder 240v
Or this
http://www.screwfix.com/p/p/17499?u..._term=Impax IM-MIG 150/20/150 MIG Welder 240v
I have done a little arc welding a couple of years ago but apart from that I haven't had much experience
Any advice would be helpful please
I need to get myself a welder for a steel boat project I'm working on
Firstly I will need to weld some 16mm round steel bar onto the edges of some 2mm steel sheet
What would be the best way to weld this ? Arc or mig ?
I was looking for something not to expensive and as I will be working in the open I was thinking either a small gasless mig or a stick welder
I have been looking at...
http://www.screwfix.com/p/p/17497?u...Impax IM-ARC140/10/115 140amp Arc Welder 240v
Or this
http://www.screwfix.com/p/p/17499?u..._term=Impax IM-MIG 150/20/150 MIG Welder 240v
I have done a little arc welding a couple of years ago but apart from that I haven't had much experience
Any advice would be helpful please