Powermandan
Member
- Messages
- 58
If you see in the photo I have cut a large section out that had seen better days, approx 1m Long the repair panel goes up about an inch above the body groove,
Haven't got the panel yet, but worried about trying to seem weld such a long length with no real ability to get any clamps on it. I have a pair of joglers but have never used them.
What's the best way to go about it? Also what do you think I should do with the vertical edges. I've left about a cm each side of the original panel but I can't see how I would attach the panel if I remove them, however would be cleaner finish probably if I did