S st1g New Member Messages 1 Location Abergavenny Dec 30, 2016 #1 Hi does anyone have plans for a twin axle trailer ? i want to make one around 8 x 4
cumbriasteve Moderator Messages 9,645 Location Cumbria UK Dec 30, 2016 #2 Welcome to the forum: This may help, perhaps you could do a project thread to show us all how it goes? http://www.mig-welding.co.uk/forum/threads/twin-axle-8x4-trailer.24805/
Welcome to the forum: This may help, perhaps you could do a project thread to show us all how it goes? http://www.mig-welding.co.uk/forum/threads/twin-axle-8x4-trailer.24805/
angellonewolf Member Messages 8,117 Location bristol england Dec 30, 2016 #3 just to add might be worth looking at what your local tip will allow if you want it for tip runs aswell mate of mine had to reduce his by a half a foot to use it for the tip
just to add might be worth looking at what your local tip will allow if you want it for tip runs aswell mate of mine had to reduce his by a half a foot to use it for the tip
colnerov Member Messages 4,619 Location Nr Gatwick UK Dec 30, 2016 #4 Hi, There're a few points in that thread that are not relevant now. This might be a better thread to peruse before embarking on this because the rules have been tightened up in regards to certification. http://www.mig-welding.co.uk/forum/threads/car-trailer-iva.53191/ Colin
Hi, There're a few points in that thread that are not relevant now. This might be a better thread to peruse before embarking on this because the rules have been tightened up in regards to certification. http://www.mig-welding.co.uk/forum/threads/car-trailer-iva.53191/ Colin