arther dailey
Member
- Messages
- 5,991
- Location
- England
Hi
managed to buy a TA 181 for reasonable monies, as new condition,tested before I paid, no problems. Finally found half hour to give it thorough test and yes very pleased with it, everything works, well dont know about tig as yet to get a torch/gas.
Anyways the one thing I cant seem to alter is working on mig you have a post flow of perhaps two seconds of gas, my question being is can I stop/alter this as being mig cant see the point it going for that long.
All and any advice welcomed, thanks Arther
managed to buy a TA 181 for reasonable monies, as new condition,tested before I paid, no problems. Finally found half hour to give it thorough test and yes very pleased with it, everything works, well dont know about tig as yet to get a torch/gas.
Anyways the one thing I cant seem to alter is working on mig you have a post flow of perhaps two seconds of gas, my question being is can I stop/alter this as being mig cant see the point it going for that long.
All and any advice welcomed, thanks Arther