eric_knapper
Member
- Messages
- 82
I have what I think is a TG75 milling collet chuck the nut was really tight but I managed to get it loose but after 1 turn it just tightens up again to the point that I feel if I put any more pressure on it I might start damaging the body of the chuck.
The collet inside the chuck doesn't seem to move so not sure if it's attached to the nut like an ER type collet or not.
Anyone know about this type of chuck? It has an indexable cutter in it and I'm only trying to get that out so I can identify the type of inserts I need for it otherwise I'd leave it in there and just get some new inserts if I knew what type they are.
The collet inside the chuck doesn't seem to move so not sure if it's attached to the nut like an ER type collet or not.
Anyone know about this type of chuck? It has an indexable cutter in it and I'm only trying to get that out so I can identify the type of inserts I need for it otherwise I'd leave it in there and just get some new inserts if I knew what type they are.