I have a Craftsman MIG Welder that I am wanting to switch from flux to gas. Problem is the hose that connects to the back of the welder for gas is TINY and I haven't come across anything that would allow me to couple it to a tank. Below are a couple of pictures of what I am talking about.
This is a picture of where the hose connects to in the back. Seems that all you do is just slide it in until it's snug and you're done.
http://s274.photobucket.com/albums/jj259/thesykboy03/?action=view¤t=Connector1.jpg
This one is one the hose is in. How do I hook this up to a tank of shielding gas? Anyone have a setup like this that can give me direction?
http://s274.photobucket.com/albums/jj259/thesykboy03/?action=view¤t=Connector2.jpg
TIA
-Jason
This is a picture of where the hose connects to in the back. Seems that all you do is just slide it in until it's snug and you're done.
http://s274.photobucket.com/albums/jj259/thesykboy03/?action=view¤t=Connector1.jpg
This one is one the hose is in. How do I hook this up to a tank of shielding gas? Anyone have a setup like this that can give me direction?
http://s274.photobucket.com/albums/jj259/thesykboy03/?action=view¤t=Connector2.jpg
TIA
-Jason