james butler
Member
- Messages
- 1,496
- Location
- birmingham england
this may sound a daft question as ive never had a euro type connection on a welder before, but what is the best method for removing the euro torch from the machine for transport?
do you unplug it and then cut the wire? or cut it after the rollers inside the machine then unplug the torch and pull the remaining wire out?
then is reinstallation just a matter of plugging it all back in and refeed the wire back through?
do you unplug it and then cut the wire? or cut it after the rollers inside the machine then unplug the torch and pull the remaining wire out?
then is reinstallation just a matter of plugging it all back in and refeed the wire back through?