rosco454
Member
- Messages
- 111
Hi,
I think this question says a lot about my welding experience (or lack of).I have a size x bottle of argoshield light,it is starting to get a bit low on pressure-80psi or so.Is there a minimum pressure i would need to maintain a flow rate of 10lpm or will the flow rate remain constant until the cylinder is virtually empty?
Reason i ask is i dont want to be caught out if the flow drops after a certain pressure if you get what i mean.
Many thanks,Ross.
I think this question says a lot about my welding experience (or lack of).I have a size x bottle of argoshield light,it is starting to get a bit low on pressure-80psi or so.Is there a minimum pressure i would need to maintain a flow rate of 10lpm or will the flow rate remain constant until the cylinder is virtually empty?
Reason i ask is i dont want to be caught out if the flow drops after a certain pressure if you get what i mean.
Many thanks,Ross.