Hi,
I have just bought a Cebora 984 plasma cutter off ebay. It is a single phase machine and it is complete with all leads etc. It does require an additional compressed air supply which is no problem.
Some questions:
Do you need to wear a welding mask for plasma cutting?
What air supply pressure do these machines need to run optimumly?
Do the tips wear very quickly - are they very sacraficial?
Are parts for this machine readily available?
What sort of start will this machine have - HT or scratch?
(aksking this as have read about it on the forum).
What sort of thickness will this cut through - mild steel?
Thanks in advance for any advice or tips as this is new to me.
Maybe there should be a seperate Plasma Cutting section on the forum?
I have just bought a Cebora 984 plasma cutter off ebay. It is a single phase machine and it is complete with all leads etc. It does require an additional compressed air supply which is no problem.
Some questions:
Do you need to wear a welding mask for plasma cutting?
What air supply pressure do these machines need to run optimumly?
Do the tips wear very quickly - are they very sacraficial?
Are parts for this machine readily available?
What sort of start will this machine have - HT or scratch?
(aksking this as have read about it on the forum).
What sort of thickness will this cut through - mild steel?
Thanks in advance for any advice or tips as this is new to me.
Maybe there should be a seperate Plasma Cutting section on the forum?