no doubt being a forum member on other boat related sites that this will have been asked umpteenth times.
I am looking for a good reliable diy welder to do my own bits and pieces, mild steel and stainless eventually.
Dont have a huge budget but looked on ebay and have seen tig/arc/plasma cutter for £350 including postage, are these reliable enough?
I am making a few wood burning stoves from gas bottles would tig be better bet or arc ok for this?
I am looking for a good reliable diy welder to do my own bits and pieces, mild steel and stainless eventually.
Dont have a huge budget but looked on ebay and have seen tig/arc/plasma cutter for £350 including postage, are these reliable enough?
I am making a few wood burning stoves from gas bottles would tig be better bet or arc ok for this?