Screwdriver
Member
- Messages
- 10,152
Well, I'm impressed!
One to keep an eye on?
S.
One to keep an eye on?
S.
See I would say his welding looked spot on. I know the vid was speeded up but you can see he wasn't hanging about so there must of been sufficent current there to get him going straight away.I've seen his stuff before. Very very neat. Uses a metronome in some of his videos. On thing I have noticed is all his welds seem to be quite cold and don't penetrate right into the corner. I was welding some 6000 series oil parts today and made sure that root was right in there.
Liked the double rod feed so as not to leave any steps mid-bead.
If you watch when he does a long bead you can see he's holding two rods in his feed hand. As one rod runs out he feeds the second in without missing a beat.What does this mean?
@doubleboost in his other videos on a positioner he has arc shots.See I would say his welding looked spot on. I know the vid was speeded up but you can see he wasn't hanging about so there must of been sufficent current there to get him going straight away.
The thing I noticed which was rather odd was he went up the incline on one side and down on the other. It shows he has no problems going in all positions to the same standard but I'd of gone up on both sides personally.