W.olly
Member
- Messages
- 3,611
- Location
- Radcliffe, Manchester
Some will have seen that i got a table saw and swapped out the 1/2hp motor for a 3hp of one of my compressors.
New belt arrived and i fitted a new pully to suit the motor shaft.
Now on first few attempts it started slowly and wouldnt go full speed, tripped the button on the motor wiring.
I slackend the belts slightly and it still tripped but then second attempt it was ok.
So further attempts it started ok and picked up speed fine. It hasnt cut out since yesterday as i tried it again tonight and work bloody great.
Just wondering if it sound sand starts ok ?
i dont want to damage the motor or anything else infact.
I made a quick vid of it.
New belt arrived and i fitted a new pully to suit the motor shaft.
Now on first few attempts it started slowly and wouldnt go full speed, tripped the button on the motor wiring.
I slackend the belts slightly and it still tripped but then second attempt it was ok.
So further attempts it started ok and picked up speed fine. It hasnt cut out since yesterday as i tried it again tonight and work bloody great.
Just wondering if it sound sand starts ok ?
i dont want to damage the motor or anything else infact.
I made a quick vid of it.