Screwdriver
Member
- Messages
- 10,150
I'm sick of looking for one having been searching basically for years! So I snapped this one up for a pretty penny. Paid too much TBH but it's small enough, cheap enough and just up the road. Looks like this:
Needs work to rig up a decent motor solution, in fact it needs quite a lot of work now that it looks more like this!
Full info here: http://www.lathes.co.uk/taylormiller/
It's small but chunky, should easily be able to squeeze it into a corner. Might take a while to get it going again tho, I am now staring at a quarter ton of scrap.
Which I hope to make into something like this:
Close up of the OEM collet. I think it's a proprietary type, I'll know better when I whip the spindle out.
Does anyone recognise that type of collet and know where I might find some. Also would be great if anyone had some spare cutters to get me going.
S.
Needs work to rig up a decent motor solution, in fact it needs quite a lot of work now that it looks more like this!
Full info here: http://www.lathes.co.uk/taylormiller/
It's small but chunky, should easily be able to squeeze it into a corner. Might take a while to get it going again tho, I am now staring at a quarter ton of scrap.
Which I hope to make into something like this:
Close up of the OEM collet. I think it's a proprietary type, I'll know better when I whip the spindle out.
Does anyone recognise that type of collet and know where I might find some. Also would be great if anyone had some spare cutters to get me going.
S.