Luke
Forum Supporter
- Messages
- 1,929
- Location
- Whitchurch, Shropshire
There have been a few occassions recently where I needed to apply some heat to something, normally a seized part.
Recently, I borrowed a traditional style butane/propane burner, like you'd use for pipe soldering.
Doing some research, I don't want to go down the route of oxy-anything, as my low use doesn't warrant the cost or the risk/hassle of having 02 around.
I've seen MAPP gas talked about before, but have never used it, and the other alternative seems to be a hose and torch on a propane cylinder.
Any thoughts/experiences/suggestions?
Recently, I borrowed a traditional style butane/propane burner, like you'd use for pipe soldering.
Doing some research, I don't want to go down the route of oxy-anything, as my low use doesn't warrant the cost or the risk/hassle of having 02 around.
I've seen MAPP gas talked about before, but have never used it, and the other alternative seems to be a hose and torch on a propane cylinder.
Any thoughts/experiences/suggestions?