Swift&Bold
Member
- Messages
- 985
- Location
- Dan Saff!
I've been using my Mig 180 invertor for a few weeks now and previously, whenever I turned it on the fan could be heard until it was switched off, today it stopped and hasn't come on at all since.
I am using it outdoors in partial shade, there are no warning lights, I've been using it for short, frequent welds on 1mm sheet so am nowhere near the duty cycle and the welder is still welding normally (minus the fan).
Is this a fault or is it supposed to happen?
I am using it outdoors in partial shade, there are no warning lights, I've been using it for short, frequent welds on 1mm sheet so am nowhere near the duty cycle and the welder is still welding normally (minus the fan).
Is this a fault or is it supposed to happen?