Mince and tatties
Member
- Messages
- 45
- Location
- Scotland
Had a phone call about a job with caterpillar.
They are arranging a weld test for me sometime next week
all I knows is that it's a horizontal full pen butt and fillet.
I don't normally do that sort of procedure at my current work, it's normally vertical roots and fillets on the flat with flux core.
Can anyone tell me some important techniques to help me pass the test? Do I need to be pushing it or pulling it? What sort of heats, gun angle etc?
They are arranging a weld test for me sometime next week
all I knows is that it's a horizontal full pen butt and fillet.
I don't normally do that sort of procedure at my current work, it's normally vertical roots and fillets on the flat with flux core.
Can anyone tell me some important techniques to help me pass the test? Do I need to be pushing it or pulling it? What sort of heats, gun angle etc?