Afternoon everyone, First post due to needing some help as is usually the case
I bought a gasless mig to weld some market frames together and It was working quite happily until it didn't.
filling in the needed bits,,I got it from an amazon seller 'trueshopping' and its a replica of a clarke 102 but it's marked up 'mig 130' and it's a pretty powerful little beast whe working.
BUT, the wire feed packed in.
pulled the torch apart etc but found no problem , fed a 12v feed to the motor it was working.
so went deeper into the body and found a circuit board in my way so disconnected it. herein lies the trouble. I can't put the wires back in the correct position, obviously, because it now blows the electric when I turn it back on. please feel free to shoot at me and point me to a wiring diagram if you can. much obliged in advance.
I bought a gasless mig to weld some market frames together and It was working quite happily until it didn't.
filling in the needed bits,,I got it from an amazon seller 'trueshopping' and its a replica of a clarke 102 but it's marked up 'mig 130' and it's a pretty powerful little beast whe working.
BUT, the wire feed packed in.
pulled the torch apart etc but found no problem , fed a 12v feed to the motor it was working.
so went deeper into the body and found a circuit board in my way so disconnected it. herein lies the trouble. I can't put the wires back in the correct position, obviously, because it now blows the electric when I turn it back on. please feel free to shoot at me and point me to a wiring diagram if you can. much obliged in advance.