I need to bend 20x5 flat bar 180 degrees around an 8mm bolt, neatly. Any spring back would allow for clearance and is fine. I've done it previously with a 10mm bolt but just can't remember or figure out how I did it.
It's to make 8 tailgate keeps for a trailer so don't mind knocking up a quick former if need be.
I should add I have no source of heat.
I do have a Clark parts bender.
Ta for any tips
JF
It's to make 8 tailgate keeps for a trailer so don't mind knocking up a quick former if need be.
I should add I have no source of heat.
I do have a Clark parts bender.
Ta for any tips
JF