Kram
Member
- Messages
- 6,226
- Location
- Sussex
Have an MT3 ER32 collect chuck. The 10mm through hole and drawbar are limiting what I can put in it.
Plan to cut the MT3 taper off of and make it into a backplate mounting, not sure easiest way to lock it into the backplate. OD is 36mm and has a couple of flats. Interference fit/weld/keyway?
Plan to cut the MT3 taper off of and make it into a backplate mounting, not sure easiest way to lock it into the backplate. OD is 36mm and has a couple of flats. Interference fit/weld/keyway?