Dieselman 63
Forklift Certified
- Messages
- 5,640
- Location
- Wellington, New Zealand
Had fun today - 2hr tutorial on the oxy acetylene set. A lot of it turning the gas on/off, bottles on/off, torch high/low, safety, deforming and then some brazing. I was standing up whilst doing it, next time I would like to sit down as I think I could do a better job, but great fun regardless.
First up joined some steel rod, then did some plate at 90 deg. Heated the other side so that it creeped through.
Probably didn't use enough flux, and too much rod burnt but I enjoyed the experience.
First up joined some steel rod, then did some plate at 90 deg. Heated the other side so that it creeped through.
Probably didn't use enough flux, and too much rod burnt but I enjoyed the experience.