andy198712
Member
- Messages
- 31
- Location
- Cornwall
Hello,
Just got a Clarke 135TE, came with CO2 disposable bottle and 0.6mm wire.
followed the instructions for settings for ym 1.5mm plate and this is what i got:
i tried to push and to pull, and a little side to side action in the wider ones... penetration looks good from what i gather off here?
its really my first go at MIG, did a couple welds in college but thats it.
i'm open to any advice or criticism ect
very first 3
penetration
picture above were pushes, these were pulls, i tried one a little faster to experiment, which you can see
push and pulls as noted
this was with a little side to side movement too
any input? do they look ok?
cheers
Andy
Just got a Clarke 135TE, came with CO2 disposable bottle and 0.6mm wire.
followed the instructions for settings for ym 1.5mm plate and this is what i got:
i tried to push and to pull, and a little side to side action in the wider ones... penetration looks good from what i gather off here?
its really my first go at MIG, did a couple welds in college but thats it.
i'm open to any advice or criticism ect
very first 3
penetration
picture above were pushes, these were pulls, i tried one a little faster to experiment, which you can see
push and pulls as noted
this was with a little side to side movement too
any input? do they look ok?
cheers
Andy