Easyrider
Member
- Messages
- 22
Hi All...
After a prolonged welding session I managed to damage the thread of the end cap?? I hadn't noticed anything unusual until I tried to remove it to
clean the tung.... Struggled to uncrew it and when I used pliers it broke apart.
I have it out now and it did unscrew reluctantly but i can see at least one damaged thread.
Q. If i run a tap threw it it should be fine but what is it ... here are the dims
9.3mm OS (0.37in) .8mm Pitch
Is this BSP or BSF ?
Machine is Tech Arc 206i so its an WP18 type end cap
Thanks in advance
After a prolonged welding session I managed to damage the thread of the end cap?? I hadn't noticed anything unusual until I tried to remove it to
clean the tung.... Struggled to uncrew it and when I used pliers it broke apart.
I have it out now and it did unscrew reluctantly but i can see at least one damaged thread.
Q. If i run a tap threw it it should be fine but what is it ... here are the dims
9.3mm OS (0.37in) .8mm Pitch
Is this BSP or BSF ?
Machine is Tech Arc 206i so its an WP18 type end cap
Thanks in advance