Carl Wilson
Member
- Messages
- 1,957
- Location
- Moray
Hello,
New to this forum and my first post. I'm going to fit a 2 axis DRO system to my Harrison M250 lathe. I've been looking at kit from EMS international.
They tell me that they can supply me a magnetic scale for the cross slide and a glass for the bed. These are made specifically for Harrison and Colchester machines. So I'm told.
The magnetic on the cross is because it is lower profile.
So I wondered if anyone here has had a system from EMS specific to a Harrison. If do, how did fitting and using it go?
Thanks,
Carl.
New to this forum and my first post. I'm going to fit a 2 axis DRO system to my Harrison M250 lathe. I've been looking at kit from EMS international.
They tell me that they can supply me a magnetic scale for the cross slide and a glass for the bed. These are made specifically for Harrison and Colchester machines. So I'm told.
The magnetic on the cross is because it is lower profile.
So I wondered if anyone here has had a system from EMS specific to a Harrison. If do, how did fitting and using it go?
Thanks,
Carl.