Tinbasherdan
Bodger in chief
- Messages
- 7,039
- Location
- Bolton, England
how do, I have a couple of 3 jaw chucks with corresponding back plates but they aren't running quite square , there's movement in it with the bolts slackened, so how would you square it up?
I was thinking putting a taper in the tailstock, running it forward and holding it in the jaws of the chuck while I nip the backplate up , should get it somewhere near right?
I was thinking putting a taper in the tailstock, running it forward and holding it in the jaws of the chuck while I nip the backplate up , should get it somewhere near right?