dobbslc
Member
- Messages
- 10,909
- Location
- Hertfordshire UK
I'm trying to skim a small (200mm from the rear of a motorcycle) brake disc on my lathe, what's the best way to dial it in on a 3 jaw chuck to run true?
I'm not sure it's even possible to take a small skim off it but worth a try before splashing out £45 on a new one!
I have a dial gauge etc.
Thanks
I'm not sure it's even possible to take a small skim off it but worth a try before splashing out £45 on a new one!
I have a dial gauge etc.
Thanks