Weldingweb928!
New Member
- Messages
- 1
- Location
- United States
I have a completely dead Maxstar 200DX. I found some damaged components on PC2 and also P10 and replaced them and tested a lot of other components and they all seem fine. Powered back up it’s still the same. I have it hooked to 110v power. It just seems to be VAC power throughout all the boards? I got a good deal on a new power module and put that in thinking it was it but it’s the same story. Does any have the technical service manual for one of these welders and the pre-power checks? Any info would be greatly appreciated. Thanks Gerry