I have just been given an old Maypole turbo mig 130 but have no manual.
I'm trying to interpret the data plate and control settings .
There seem to be 4 power settings and there are 4 columns on the data plate three of which seem to be headed by the kva usage and the fourth by "fuse". Does this mean the fourth setting cannot be used ?
Also I have read that if fluxed wire is to be used rather than using a separate gas supply one should change the polarity of the wire to -ve. How is this done?
I would appreciate any enlightenment on the above.
I was intending to to add photos of the data plate etc but have not found how to do that. I've tried below
Thanks Cosh
I'm trying to interpret the data plate and control settings .
There seem to be 4 power settings and there are 4 columns on the data plate three of which seem to be headed by the kva usage and the fourth by "fuse". Does this mean the fourth setting cannot be used ?
Also I have read that if fluxed wire is to be used rather than using a separate gas supply one should change the polarity of the wire to -ve. How is this done?
I would appreciate any enlightenment on the above.
I was intending to to add photos of the data plate etc but have not found how to do that. I've tried below
Thanks Cosh
Last edited: